Want to Pass 400-201 Exam In Next HOURS? Get it now →
May 18, 2017

Top Up to date 400-201 exam engine Reviews!

High value of 400-201 test question materials and cram for Cisco certification for IT candidates, Real Success Guaranteed with Updated 400-201 pdf dumps vce Materials. 100% PASS CCIE SP Written v4.0 exam Today!

Q21. A telecom company offers ISPs the ability to resell dynamic IP broadband services over its local loops, but it does not allow the resellers to install broadband network gateways. If an ISP wants to become a reseller but is unable to use NHRP, which tunneling protocol should be implemented? 

A. IP in IP 

B. IPsec 

C. L2TP 

D. GRE 

Answer:

Explanation: 

However, while OpenVPN can not be used with VoIP, L2TP can be used for VoIP. Only use this if OpenVPN is not available and you are in need of very high security/encryption. 


Q22. Which is the main goal of BGPsec regards to improve BGP security? 

A. Reduces risk of improper route propagation from unauthorized AS numbers 

B. Configures BGP route verification by storing routes in a database used to validate AS numbers 

C. Adds encryption to route propagation outside the iBGP AS 

D. Increases legitimacy and authenticity of BGP advertisements 

Answer:

Explanation: Reference: https://tools.ietf.org/html/draft-lepinski-bgpsec-overview-00 


Q23. Based on the following configuration: 

Which two statements about multicast VPN configuration are true? (Choose two.) 

A. The multicast tree is created based only on the existence of active sources or receivers behind PEs in the ABC VRF. 

B. The service provider core network is required to support SSM. 

C. Multicast needs to be enabled only on ABC VRF and is tunneled to participating PE routers in the ABC VRF. 

D. The SP core network is required in order to enable the BGP Multicast Address Family on all peering. 

E. Multicast is required for the core network in addition to the ABC VRF. 

F. The multicast tree exists regardless of whether there are any active sources or receivers in the ABC VRF. 

Answer: E,F 

Explanation: http://www.ciscopress.com/articles/article.asp?p=32100&seqNum=4 

http://www.cisco.com/en/US/tech/tk828/technologies_white_paper09186a00800a3db6.sht ml 


Q24. How many bits are expressed by";:" in the address 2D01:DB::C:B7BA:130B? 

A. 16 bits 

B. 32 bits 

C. 40 bits 

D. 44 bits 

E. 48 bits 

F. 52 bits 

G. 56 bits 

H. 64 bits 

Answer: E


Q25. What is the PPMP label used for? 

A. for the ingress replication model with BIDIR-PIM in an overlay model 

B. only for the inter-AS mVPN models that use mLDP 

C. for the partitioned mVPN model with PIM signaling in an overlay model 

D. only for unicast over MPLS VPN 

E. for all the default MDT and mVPN models 

Answer:

Explanation: http://lostintransit.se/tag/bgp/ 

https://tools.ietf.org/html/draft-rosen-l3vpn-mvpn-mspmsi-08#section-3.2.2.1 


Q26. QoS is applied on an outgoing interface as shown below: 

What will the QoS result be for egress traffic with an average queue depth of 40 that is marked as DSCP AF32? 

A. Traffic will be dropped with a random rate less than the one defined by MPD. 

B. All traffic will be tail dropped. 

C. Traffic will be dropped with a rate of 1 packet out of 20. 

D. Traffic will be dropped with a rate of 1 packet out of 30. 

Answer:


Q27. Refer to the exhibit. Router RT1 has three equal-cost paths back to the source. Which configuration should be applied in order to load-balance the multicast traffic across all three links. 

A. Create three static multicast routes where each pointing out to one or three interfaces. 

B. Enable PIM multipath. 

C. Create a tunnel interface between RT1 and RT2. Enable PIM on the interface tunnel and disable PIM on the three interfaces part of equal-cost path between RT1 and RT2. 

D. PIM load balance is not possible. PIM only chooses one interface for RFC check and prunes the other interfaces. 

Answer:

Explanation: 

Reference: http://www.cisco.com/c/en/us/support/docs/ip/ip-multicast/16450-mcastguide0.html 


Q28. What are three actions that the control word performs in MPLS AToM? (Choose three.) 

A. is used to identify the VC label 

B. is used for padding small packets 

C. preserves the sequence of the transported frames 

D. facilitates the load balancing of AToM packets in the MPLS backbone network 

E. carries control bits of the Layer 3 header of the transported protocol 

F. is used to identify the tunnel label 

Answer: B,C,D 

Explanation: https://ccdewiki.wordpress.com/2013/05/28/control-word-on-atom/ 


Q29. Two Service Providers are beginning a merger between AS boundaries to provide MPLS-enabled services between their networks. Customers are using both Service Providers for services and, under certain circumstances; there are requirements to extend Layer 2 VPN circuits between each provider. The providers are in the process of completing the technical merger. However, the MPLS is not supported between the providers. Which action allows MPLS Layer 2 VPN circuits to be built over the inter-AS link? 

A. Create a GRE tunnel with the mpls ip command between ASBRs. 

B. Create Layer 2 VPN peerings between PE routers from each provider. 

C. Create a VPNv4 peering between ASBRs to advertise labels between each provider. 

D. Create a sham link between ASBR routers to enable a superbackbone peering for Layer 2 VPN signaling. 

Answer:

Explanation: https://ccdewiki.wordpress.com/2013/07/02/inter-as-l2vpn-mpls-solutions/ 


Q30. In a virtualization concept, which is one of the characteristic of the HVR solution? A. introduces significant contention of resources 

B. implements shared control plane resources 

C. implements dedicated chassis resources 

D. implements dedicated data plane resources 

Answer:



see more free 400-201 exam dumps